If you’ve found yourself thinking about what’s wrong with your Kenmore washing machine is filling up and draining simultaneously You’re not alone. It’s a common issue and can be caused by many things. In this post, we’ll talk about some of the most prevalent causes for this issue.
We’ll also provide step-by-step instructions on how to fix a Kenmore washer that fills and drains simultaneously. Whether you’re a seasoned DIYer or an aspiring repairer, this guide will assist you in getting your Kenmore washing machine back in working order in no time.
Water Inlet Valve:
The water valve inlet to your Kenmore washing machines is used to fill the tubs with cold, hot or warm water. The electric solenoids regulate the valve. They are controlled by the electronic control board as well as the timer, water level control/water selector or the pressure switch. The water inlet valve may be the problem if your Kenmore washer fills up after the draining cycle. If the issue continues then unplug your washer. If the Kenmore washer continues to fill, then the inlet valve is malfunctioning. The problem could be related to the circuit that controls the valve. What you can do to check the water inlet valve on theKenmore washing machine with a multi-meter:
- Before you start, disconnect the water supply and power source from the Kenmore washer.
- For testing the valve, you must remove it. It’s hidden behind the hose connections. It’s necessary to disassemble every part or the cabinet of your washer to remove it.
- There may be screens in the valve that are blocked by dirt and particles. You should clean up any debris or dirt you find. The screens can’t be sold as a separate item and will need to be replaced when damaged. You must also examine the valve’s exterior for wear, damage, or cracking.
- Consult the manual of your owner as the resistance reading for a functioning valve differs among different models of Kenmore washers. When you’ve achieved the reading you want, switch your multimeter on RX1 to connect the terminals of the valve’s terminals.
- If this test indicates that the valve is not in continuity, you’ll need a Kenmore replacement water inlet valve.
Water Level Switch or Pressure Switch & Air Dome Tube:
The water level switch is a pressure activated switch which is used to determine the right level of water in the tub. It is typically located in the back of the control panel and may have a hose or air dome tube connecting it to the tub. The switch can be located underneath the tub on Kenmore washers, which have an electronic control. The water will fill up the tub and expand the air inside, pressing against the diaphragm. The water inlet valve is controlled by the switch and the valve will be shut off when the level of water is set correctly. How to test the level of water in aKenmore washing machine
- Before you start working with electrical components, you must disconnect the appliance.
- Begin by opening the Kenmore cabinet to the washer, and then taking out the air dome. Put the hose in water and seal the end. Then blow the opposite end of the hose into the water. It is necessary to replace the air dome hose when bubbles appear.
- Inspect the switch and the hose for any signs of fraying, cracking, wear, or damage.
- You can replace the water level switch in case it’s damaged.
In the end the conclusion is that the Kenmore washer that drains and fills up at the same time could be a frustrating problem to resolve If you have the right expertise and the right tools, it’s a fixable issue. You can fix it quickly. most commonly encountered problems, such as the blockage of the drain hose, malfunctioning water inlet valve, or malfunctioning pressure switch. To learn more, make sure you refer to the Kenmore washer’s owner’s manual. Make sure to unplug your machine before you attempt any repairs. With just a bit of patience and know-how and a little know-how, you’ll have your Kenmore washing machine working as new in no time.