If you’ve been thinking about what’s wrong with your Inglis washing machine is filling and draining simultaneously it’s not a problem for you. It’s a problem that is common that is caused by many different problems. In this post, we’ll discuss some of the most prevalent causes of this problem and provide step by step instructions on how to fix the Inglis washer that overflows and drains simultaneously. This guide is for those who are an expert DIYer or amateur. This guide will help you understand how to get your Inglis washer back to normal order in no matter what level you’re at.
Water Inlet Valve
The water inlet valve that is on your Inglis washing machine is used to provide the tub with cold, warm or hot water for the wash and rinse cycles. The valve is operated by electronic solenoids controlled by the electronic control board or timer and the water level control switch, or the pressure switch. If your Inglis washer continues to fill when draining it is possible that the valve for water inlet could be the cause. To verify that the valve is in error unplug the washer whenever the symptom occurs. The inlet valve may be malfunctioning if the washer fills constantly. It could be due to the circuit that controls the valve. How do you check the water inlet valve of the Inglis washing machines using the multimeter:
- Before you begin, shut off the water supply and power source from the Inglis washer.
- The valve has to be removed to test it; it can be found in the connection to the hose. It’s necessary to disassemble any or all of your cabinet for the washer in order to take it off.
- There may be screens in the valve that are blocked by dirt and other debris. It is recommended to clean any dirt or debris that you find. The screens can’t be sold on their own and need to be replaced in the event of damage. Also, check the valve’s exterior for cracking, wear, and damage.
- Read the user’s manual because the reading of resistance for a functioning valve differs among the different Inglis washers. Once you have a clear idea of the reading you should get then set your multi-meter to Rx1 and connect the probes with the terminals of the valve. If the valve isn’t in continuity, you may use the Inglis replacement valve.
The water level switch, also known as a pressure switch and air dome tube
The water level switch, which is activated by water pressure, is used to set levels of water inside the tub. It is typically located in the back of the control panel and will contain a hose, or an air dome tube that connects it to the tub. On Inglis washers that have electronic controls, this switch may be situated in the sump area under the tub. As the water fills the tub, it will compress the air inside the tube, pushing against a diaphragm inside the switch. The switch controls the valve for water inlet and stop the valve at the right level of water. How to determine the water level in the Inglis washer machine:
- Before working with electrical components, ensure that you unplug your appliance.
- Start by opening the Inglis cabinet to the washer, and then taking the air dome out. Place the hose in water to seal one end and then blow it into the other. It is necessary to replace the air dome hose in case bubbles begin to form.
- The switch and the hose should be inspected for cracking, fraying or wear.
- You can replace your water level switch in case it’s damaged. In conclusion we can say that it is true that a Inglis washing machine that drains and fills at the same time can be a hassle to deal with however, with the proper information and tools the issue can be fixed.
Through identifying the most frequent causes, such as a clogged drain hose, an inoperable water inlet valve, or a malfunctioning pressure switch, you can fix your Inglis washer back to working order in no time. For more details, be sure to consult the Inglis washer’s owner’s manual. Unplug your machine before you attempt any repairs. It is possible to get your Inglis washer operating like new with just a bit of patience and knowledge.