If you’ve ever been wondering what’s going on with your Haier washing machine is filling and draining simultaneously there’s no reason to be concerned. This is a common problem that can be caused by a variety of problems. In this article, we’ll talk about some of the most prevalent causes of this problem and provide step-by-step instructions on how to fix an appliance from Haier that fills and drains simultaneously.
If you’re an experienced DIYer or are a novice repairer, this guide can help you get your Haier washing machine back to working order in no time. Water Inlet Valve : The water valve that is in the inlet of your Haier washing machines is used to fill the tubs with cold, hot or warm water. The solenoids on the electrical circuits regulate the valve. They are controlled by the electronic control board as well as the timer, water level control/water selector switch or the pressure switch. The valve that lets water into the water can be the cause of your issue if your Haier washer fills up during a drain cycle.
To check if the valve is in error remove the washer from the outlet when the symptom occurs. If the Haier washer does not stop filling, then the valve that is inlet is damaged. If the Haier washer stops filling it is in the electrical circuit that regulates the valve. How to test the water inlet valve in a Haier washing machine using the multi-meter:
- Before starting, disconnect the power source and the water supply source to the Haier washer.
- For testing the valve, remove it. It’s hidden between the hose connections. To remove the valve you’ll have to remove the cabinet of your washer.
- Inside the valve, you’ll find screens that might have deposits of dirt or debris. You should clean up any dirt or debris you discover. Screens cannot be sold as a separate item and will need to be replaced if damaged. Also, inspect the valve’s exterior for cracking wear and damage.
- he owner’s manual you have will give the resistance readings needed for valves that are functional. They differ among Haier washer models. Once you have the reading you want, switch your multimeter on RX1 to be in contact with the terminals of your valve’s terminals. 5.If this test indicates that your valve isn’t in continuity, you’ll need an Haier replacement water inlet valve.
The water level switch, also known as a pressure switch and air dome tube:
The water level switch, activated by the pressure of water, is used to control the water level within the tub. The switch is usually located behind the control panel and may have a hose or air dome tube which connects it to the tub. For Haier washers that use electronic controls switch, the switch might be situated in an area called the sump that is under the tub. When the water is filled into the tub it will compress the air in the tube, pushing against a diaphragm inside the switch. The switch controls the water inlet valve and turn the valve off at the proper water level. How to check the level of water in the Haier washer machine:
- Since you will be working using electrical components, ensure that you’ve unplugged the appliance prior to starting.
- Start by opening the Haier cabinet to the washer. Then, remove the air dome hose. Set the hose in the water then seal one end and then blow it into the other. You’ll need to replace the air dome hose if bubbles begin to form.
- The switch and the line for any indications of fraying, cracking, wear or damage.
- If you find your switch has been damaged and you require an Haier replacement water switch. An Haier washer that drains simultaneously can be frustrating. However, with the appropriate tools and expertise, the problem is easily fixed. You can fix it quickly. most frequent issues, such as a blocked drain hose, defective water inlet valve or an issue with the pressure switch.
To learn more, make sure to consult the Haier washer’s owner’s manual. Also, disconnect your machine before you attempt any repairs. You can have your Haier washer running like new with a little patience and understanding.